What is Fox boost valve?
Fox boost valve is in the compression fluid flow channel, having variable port size which closes smaller restricting fluid progressively as the shaft displacement’s reserve chamber air or nitrogen pressure increases during compression travel.
What is a boost valve?
What is a boost valve? The TV boost valve influences line pressure in accordance to the throttle valve pressure cable stroke. The low-int/reverse boost valve provides a static pressure increase as well as determining the fixed line pressure value in manual 2nd and 1st ranges.
What does a turbo boost control valve do?
A boost controller is a device to control the boost level produced in the intake manifold of a turbocharged or supercharged engine by affecting the air pressure delivered to the pneumatic and mechanical wastegate actuator.
How much air should I put in my Fox Float shock?
To achieve the best performance from your FOX suspension, adjust the air pressure to attain your proper sag setting. Sag is the amount your suspension compresses under your weight and riding gear. Sag range should be set to 25–30% of total shock travel.
Why is my FOX shock losing air?
The only way you can lose air from the system is if the shock pump seal or shock valve pin is damaged. Hair, dirt or damage to the pump head seal will allow air to creep out between the valve and pump head and lose pressure.
How do I increase rebound damping on my shocks?
Increase rebound damping by turning the red rebound knob clockwise (when viewed from the end of the shock with the air valve) until when tested, the shock returns quickly but does not top out. Top out is felt when a shock fully extends too quickly and comes to an abrupt stop when it reaches full extension (you will hear/feel a small noise).
How do you adjust SAG and rebound on a shock absorber?
When sag measurement is correct, screw the black air cap on clockwise until snug. Rebound controls the rate of speed at which the shock extends after compressing. Turning the red rebound knob clockwise (in) slows down rebound, turning the red rebound knob counter-clockwise (out) speeds up rebound.
How do you adjust the air pressure on CTD shocks?
FLOAT CTD shocks have a maximum pressure of 300psi. Unscrew the black air cap to expose the schrader valve. Slide your shocks sag setting o-ring up against the shock dust wiper. Rotate the CTD lever to the Descend mode (fully counter-clockwise).
How do I Set my shocks to descend mode?
Slide your shocks sag setting o-ring up against the shock dust wiper. Rotate the CTD lever to the Descend mode (fully counter-clockwise). If you have a FLOAT CTD Remote shock, click the black release lever once to set the shock to Descend mode.