What would cause a Honda Civic not to start?

What would cause a Honda Civic not to start?

The most common reasons a Honda Civic won’t start are a dead battery, an alternator problem, or failed starter.

How do you bypass the immobilizer on a 2002 Honda Civic?

To reset the 2002 honda civic immobilizer place the key in the driver’s side door lock, unlock it, lock it, then unlock it again. Then you can place your key in the ignition and let it run for at least ten minutes.

Does a 2002 Honda Civic have a distributor?

2002 Honda Civic Distributor – from $43.99+ | AutoZone.com.

How do I get my Honda Civic out of anti theft mode?

To do this, insert the key into the ignition and turn it to the accessory position, but dont start it. Press and hold the security reset button for about three seconds, it is on the drivers kick panel, next to the hood release lever. The security light will stop flashing and remain solid.

What is FI ECU fuse?

An engine control unit (ECU), also known as an engine control module (ECM), is a type of electronic control unit that manages a set of actuators in an internal combustion engine. In a fuel injection (FI) system, the ECU controls the amount of fuel injected into the engine.

What should I do if my starter switch is not working?

Maybe you should try replacing all the engine management, ignition, starter switch fuses. I thought my issue was more serious and ended up being a fuse. Show activity on this post.

Why won’t my Denso crank start?

Buy a new denso (same OEM) still crank wont start. Start to think maybe the main relay (s) are damage (or going to be). For some reason I disconnect the Crank sensor cable, and the car start. Keep do the same; crank it with crank cable on (do not start), crank it with the cable off (and it start.).

What happens when a crankshaft sensor fails?

Forgot to add that when a crankshaft sensor fails the PCM will automatically keep the injectors from injecting fuel on some cars. The fuel pump will sometimes still work and the pressure is good and all but the injectors will not work unless the PCM is recieving a signal from the crank sensor.