Are Juniper firewalls any good?
Juniper is a good candidate for enterprises desiring high throughput at low cost and advanced routing support, and for those combining security and networking purchases. Ease of management, branch office offerings and software-defined secure network (SDSN) technology are also positives. Value: Very Good.
How do I check traffic on my NetScreen firewall?
From the web-based GUI on a NetScreen firewall/router, such as the NetScreen 5GT, you can check the bandwidth utilization by clicking on Reports then selecting Interface Bandwidth. On the above screen shot, the total utilized bandwidth for all interfaces is 0 Kbps.
What is the purpose of the discard action of a firewall filter?
Each firewall filter has an implicit discard action at the end of the filter, which is equivalent to the following explicit filter term. Therefore, if a packet matches none of the terms in the filter, it is discarded.
What is the purpose of the discard action of a firewall filter Junos?
What is the purpose of the discard action of a firewall filter? A. The system silently drops the packet.
What is firewall Juniper?
Juniper firewalls support a concept called virtual routers. This is often useful to help segment your internal routing domain so routes are not leaked to other routers. In addition to destination-based routing, Juniper firewalls support source-based routing, source interface–based routing, and multicast.
What is Juniper SRX firewall?
Juniper Networks® SRX Series Services Gateways are high-performance network security solutions for enterprises and service providers that deliver security, routing, and networking capabilities. SRX Series devices provide a complete security solution to protect and control your business assets.
What are three terminating actions for firewall filters?
accounting-profile.
What are two functions of the packet forwarding engine choose two?
The Packet Forwarding Engines provide the Layer 2 and Layer 3 packet switching, forwarding, and route lookup functions. In a maximum configuration with eight Type 3 FPCs installed, the Packet Forwarding Engines can forward up to 640 million packets per second (Mpps) for all packet sizes.
What is a firewall filter on a router?
Firewall filters provide a means of protecting your router (and switch) from excessive traffic transiting the router (and switch) to a network destination or destined for the Routing Engine. Firewall filters that control local packets can also protect your router (and switch) from external incidents.
How to configure a firewall to filter out traffic on egress?
Apply the firewall filter as output on the egress interface. This firewall will filter out the traffic when the traffic is leaving ae1. Enable per-unit-scheduling on the interface so that all the units will be applied with the CoS configuration.
How do I set up a firewall to block traffic from ge-0?
Here is how you do it: Note: Monitor the ddn queue and ddn scheduler. Select a firewall filter to filter the traffic coming from source 10.132.245.0/24 to forward the traffic to a particular forwarding-class. Apply the firewall filter as output on the egress interface. This firewall will filter out the traffic when the traffic is leaving ge-0/0/0.
How to filter out the traffic when it leaves ge-0/0/0?
This firewall will filter out the traffic when the traffic is leaving ge-0/0/0. Enable per-unit-scheduling on the interface, so that all the units will be applied with the CoS configuration. Select different kinds of schedulers that configure the priority rate and the amount of traffic that can be transmitted.